Fleece (FPE-CRR-20-0806) 2007.5-2016 Cummins Regulated Return Fuel Distribution Block
Fleece 2007.5-2016 Cummins Regulated Return Fuel Distribution Block FPE-CRR-20-0806
2007.5-2016 Cummins Regulated Return Fuel Distribution Block
The Fleece Performance Cummins Regulated Return Fuel Distribution
block takes our standard fuel distribution block to the next level by
fully integrating a high flow pressure regulator. This feature in
combination with high flow aftermarket electric fuel pumps without built
in pressure regulation provides more consistent fuel pressure at the
CP3. It also has one additional return line port, and one additional
feed line port. The additional return line port allows you to remove the
factory fuel pressure relief valve hard line and fuel injector return
galley hard line to provide clearance for high flow side draft intakes,
common on competition engines. The two feed line ports allow you to run
two lift pumps to ensure you always have enough fuel volume. Metric
straight thread to AN fittings and hose are included to replace the
aforementioned hard lines and plumb those returns to the regulated
return distribution block (NOTE this kit does not include 1/2” (-8AN) or
3/8” (-6AN) fuel line to feed the distribution block or return to the
tank). There is also a 0-60 psi pressure gauge included to allow for
quick visual checks of fuel pressure set-point.
Regulation pressure
is preset at 20 psi, which is optimal for high RPM CP3 pump operation.
Additional regulation pressures can be easily obtained by swapping the
internal regulator spring.
NOTE: This kit is designed to be used with a 6.7L rail and (2) 6.7L CP3 pumps. It will work on a 5.9L block as long as a 6.7L rail and (2) 6.7L CP3 pumps are used.
Kit Includes:
• Fuel Distribution Block with Integrated 20PSI Regulated Return
• (2) Push Lock CP3 Feed Fittings
• (4) -6AN to M12 Fittings
• (1) -6AN 120⁰ to Push Lock Fitting
• (6) -6AN 90⁰ to Push Lock Fittings
• (1) -6AN 45⁰ to Push Lock Fitting
• (1) -6AN Straight to Push Lock Fitting
• (1) -8AN Straight to Push Lock Fitting
• (1) -8AN 90⁰ to Push Lock Fittings
• (2) -8AN 45⁰ to Push Lock Fitting
• (5) -6 to 9/16”-18 Straight Male Fittings
• (4) -8 to 3/4”-16 Straight Male Fittings
• (6’) -6AN (3/8”) Push Lock Hose
• (4’) -8AN (1/2”) Push Lock Hose
• (1) 0 - 60 PSI Stainless Steel-Case Liquid-Filled Gauge with 1-1/2" Dial
• (2) M8x1.25 x 55mm Stainless Steel Socket Head Cap Screws
***VERIFY THAT YOUR FUEL PUMP/LIFT PUMP CAN
OPERATE AT 20+ PSI CONTINUOUSLY OR DAMAGE MAY
OCCUR!
***DO NOT USE THE FACTORY RETURN LINE TO RETURN
FUEL TO THE TANK. IT IS TOO RESTRICTIVE.
***USE TEFLON TAPE OR ANTISIEZE ON
THREADS WHEN INSTALLING A GAUGE IN THE 1/8” NPT PORT(S)